» Moulding assembly machine – Universal
For mouldings on coffin bottom, shot from below
For mouldings on coffin top, shot from below
– Direct cost reduction through savings in time
– Universally applicable for different types of mouldings
– Automatic alignment and clamping of the coffin part and the moulding
– Minimum set-up time
– Optimisation of the production process
– Efficient mode of operation
As a single workplace with manual feeding
As a workplace in a production line with automatic flow
Customer specific requirements
Coffin part
Length 480 mm – 2.100 mm
Width 25 mm – 150 mm
Height 10 mm – 30 mm
Coffin part
Length 480 mm – 2.100 mm
Width 250 mm – 400 mm
Cycle time
16–20 seconds with 11 pneumatic nail guns
» Moulding assembly machine
For short parts and long parts
– Direct cost reduction through savings in time
– Universally applicable for different types of mouldings
– Automatic alignment and clamping of the coffin part and the moulding
– Minimum set-up time
– Optimisation of the production process
– Efficient mode of operation
As a single workplace with manual feeding
As a workplace in a production line with automatic flow
Customer specific requirements
Length: short parts 450 – 650 mm
Length: long parts 1.600 – 2.020 mm
Width: 250 – 380 mm
» T-moulding assembly machine
For T-shaped mouldings
– Direct cost reduction through savings in time
– Automatic alignment and clamping of the coffin part and the moulding
– Minimum set-up time
– Optimisation of the production process
– Efficient mode of operation
As a single workplace with manual feeding
As a workplace in a production line with automatic flow
Customer specific requirements
Length: short parts: 400 – 800 mm
Length: long parts: 1.500 – 2.100 mm
» Bead-moulding assembly automat
For bead mouldings on the coffin bottom, shot from below
– Direct cost reduction through savings in time
– Automatic alignment and clamping of the coffin part and the moulding
– Minimum set-up time
– Optimisation of the production process
– Efficient mode of operation
As a single workplace with manual feeding
As a workplace in a production line with automatic flow
Customer specific requirements
Length: side parts 1.550 – 2.200 mm
Length: head or foot parts 250 – 700 mm
Part width at 90° 50 – 650 mm
Part height ≤ 40 mm